bike pedal wall hanger Dan pedal hook – DaHÄNGER

bike pedal wall hanger Dan pedal hook – DaHÄNGERThe Dan pedal hook is a horizontal bike storage system. Dan holds the bikes at a 25 degree angle from the wall, allowing for staggered installation. You can hang up to three bikes on an 8 foot tall wall. (one pedal hook per bike needed) This is by far the most space saving solution when it comes to floor space and square footage. Dan comes with a fun sticker sheet including a KOM jersey and two sets of googly eyes stickers which conceal two of the

The Dan pedal hook is a horizontal bike storage system. Dan holds the bikes at a 25 degree angle from the wall, allowing for staggered installation. You can hang up to three bikes on an 8 foot tall wall. (one pedal hook per bike needed) This is by far the most space saving solution when it comes to floor space and square footage. Dan comes with a fun sticker sheet including a KOM jersey and two sets of googly eyes stickers which conceal two of the four screws. Made in the USA - laser cut, bend and powder coated steel. (11ga) Holds up to 65lbs. Works with all pedals, including Speedplay and Eggbeaters. For bikes with a bar width up to 34" or 863mm and pedals up to 5" (127mm) wide. Each set includes one pedal hook, two wheel shelves, hardware kit and sticker kit.

Add the Dan pants. (protective felt pad)

Pedals that don't fit: (Powertap P1, Syntace No.9, oneUp, Kona Wah Wah and RaceFace Atlas, One Up components pedals will not fit in the gap by 2mm. You can file open the gap to make it work) or get the DaBigRing with a large gap instead.